Loop Installation Guide 1. The detector should be installed in a waterproof housing as close to the loop as possible. 2. The loop and feeder should be made from insulated copper wire with a minimum cross-sectional area of 1.5mm2 . The feeder should be twisted with at least 20 turns per metre. Joints in the wire are not recommended and must be soldered and made waterproof. Faulty joints could lead to incorrect operation of the detector. Feeders which may pick up electrical noise should use screened cable, with the screen earthed at the detector. 3. The loop should be either square or rectangular in shape with a minimum distance of 1 metre between opposite sides. Normally 3 turns of wire are used in the loop. Large loops with a circumference of greater than 10 metres should use 2 turns while small loops with a circumference of less than 6 metres should use 4 turns. When two loops are used in close proximity to each...
Very informative and creative content. This concept is a good way to enhance the knowledge.thanks for sharing Automatic Barrier
回复删除Good post...
回复删除Automatic boom barrier manufacturers
Technest.ae offers professional sliding door setup services. Our experienced team can provide a comprehensive solution to suit your individual needs.
回复删除Thanks
Automatic boom barrier installation services